Hardware manual

A
A
P
P
P
P
E
E
N
N
D
D
I
I
X
X
A
A
–
–
W
W
I
I
R
R
E
E
L
L
E
E
S
S
S
S
S
S
E
E
T
T
U
U
P
P
A-9 990-0000058-1000
Rev. B
Configure the WET11 for EdgeTech wireless networking
Follow these steps to use the laptop’s Web Browser (Internet Explorer) to configure
the Linksys WET11 Ethernet Bridge using a wired Ethernet connection.
Before proceeding to the actual setup, ping the WET11 from the laptop to test the
wired Ethernet connection. Run “ping 192.168.1.225 -t” from the Windows command
shell. If this ping fails then repeat the steps to “Prepare a replacement WET11 for
wired access configuration” and refer to “Troubleshooting wired LAN Ethernet
connection”. If it still fails, contact Linksys for support ((http://www.linksys.com
).
1. Start a Web Browser, for example: Internet Explorer.
2. In the Web Browser’s Address field, type http://192.168.1.225 and hit “Enter”.
3. WET11 Logon page: leave the User name blank and type “admin” as Password
(all lower case), then click the “OK” button to log on.