Users Manual Part 1

D12
Sept
IB-**
Specifications Troubleshooting
Box contents
Note: Images are for illustrative purposes only and may differ from the actual product.
Illustration
1. Power switch
2. Power cable
3. Line out
4. AUX input
5. Line in
6. Bass dial
7. Treble dial
Bluetooth input
Power output: R/L (treble): 15W+15W R/L(mid-range and bass): 20W+20W
Frequency response: 54Hz-20KHz
Audio input: AUX, Line in, Bluetooth
Audio output: Line out
Declaration for EU
Frequency Band: 2.402GHz ~ 2.480GHz
RF Power output: ≤20 dBm (EIRP)
There is no restriction of use.
Remote control Connection
Line in input
Stereo Bluetooth Speaker
User manual
Remote control Speaker
3.5mm-RCA audio cable
⑦ ⑧
⑥
③②① ④ ⑤
⑨
1. Power on/off
2. Volume up
3. Previous track/next track
(Bluetooth input)
4. Pause/play
(Bluetooth input)
5. Volume down
6. Movie mode
(extended sound field,
ideal for watching movie)
Note:
1. Do not place the remote control in places that are hot and humid.
2. Do not charge the batteries.
3. Remove the batteries when unused for a long period of time.
4. The battery should not be exposed to excessive heat such as direct sun, fire or similar.
5. Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type.
Battery loading:
Please refer to the illustration to open the
battery compartment, insert the CR 2032
battery and close the compartment.
or
• Press the "volume/input" dial on the speaker to switch to AUX input (green light flashing once) or
Line in input (green light flashing twice).
• Respectively press the "AUX"/"LINE" button on the remote control to switch to AUX/Line in input.
• Press the " " button on the remote control or press the "volume/input" dial on the speaker to
switch to Bluetooth input, blue light will flash rapidly.
• Set your mobile phone to search for and connect to "EDIFIER D12", after pairing is successful, the
blue light will be steady lit.
• To disconnect Bluetooth, press and hold the " " button on the remote control or press and hold the
"volume/input" dial on the speaker for 2 seconds.
Note:
• To enjoy all Bluetooth functions of this product, please ensure your audio source device has A2DP
(Advanced Audio Distribution Profile) and AVRCP (Audio Video Remote Control Profile) profile.
• Bluetooth connectivity and compatibility may differ amongst different source devices, depending
on the software versions of source devices.
7. Music mode
(highly restored on-site sound,
ideal for listening to music)
8. AUX input
9. Line in
10. Bluetooth input
Press and hold to disconnect Bluetooth
11. Mute
Note: In Movie mode, the sound field extension will change or distort sound
quality. Therefore, please enable Music mode when listening to music.
WARNING!
1. Don’t swallow the battery; danger of chemical burn.
2. The product includes a wafer battery. Swallowing this battery may lead to injury or death. Do not
place the new or old battery in where children can get to it.
3. Don’t use the product if the battery cover is missing or not closed, and keep the remote inaccessible
to children.
4. Please go to the hospital immediately if the battery is swallowed.
No sound
• Check if the speaker is ON.
• Try to turn up the volume using the volume control or remote control.
• Ensure the audio cables are firmly connected and the input is set correctly on the speaker.
• Check if there is a signal output from the audio source.
Cannot connect via Bluetooth
• Make sure the speaker is switched to Bluetooth input. If it is in other audio input modes,
Bluetooth will not connect. Disconnect from any Bluetooth device by pressing and holding
the " " button, then try again.
• Effective Bluetooth transmission range is 10 meters; please ensure that operation is within
that range.
• Try another Bluetooth device for connection.
The D12 does not turn on
• Check if main power is connected, or if the wall outlet is switched on.
Noise coming from speakers
• EDIFIER speakers generate little noise, while the background noise of some audio devices
are too high. Please unplug audio cables and turn the volume up, if no sound can be heard
at 1 meter away from the speaker, then there is no problem with this product.
8. Volume control/input selector
Input mode switch: press
Disconnect Bluetooth: press and hold (Bluetooth already connected)
Power on: press/press and hold (when powered off via remote control,
and power switch already turned on)
Power off: press and hold
9. Infrared receiver/input indicator
Green light steady lit: AUX/Line in
Blue light flashing rapidly: Bluetooth unconnected
Blue light steady lit: Bluetooth already connected
Power
Off
On
or
or
To learn more about EDIFIER, please visit www.edifier.com
For EDIFIER warranty queries, please visit the relevant country page on www.edifier.com and
review the section titled Warranty Terms.
USA and Canada: [e-mail]
South America: Please visit www.edifier.com (English) or www.edifierla.com
(Spanish/Portuguese) for local contact information.
RCA-RCA audio cable