Specifications
cTHE INTERFACE
Panel with display and 4 keys :
0/1: to turn on and off
Menu: to access the menu
+/-: to increase/decrease the various settings
Remote control
To use the remote control, point it towards the stove. A beep confirms command reception, which is
also confirmed by the command taking place.
4 keys (0/1, menu, + and -) to turn on and off and increase/decrease the temperature.
The most frequent cause of remote control malfunction is flat batteries. Replace and dispose of old
batteries.
Pressure gauge
It is mainly useful to technicians.
It is found under the pellet loading lid and shows the water pressure in the system.
USE
Before ignition. 1st Ignition: contact your local TAC (technical assistance centre).
The first few times the stove is ignited there may be a slight smell of paint, which disappears rapidly.
Before ignition, check:
• that the stove has been installed and water connected correctly (make sure the system has been bled)
• the electrical power supply (turn the switch on the electrical socket to 1)
• the door is closed.
• the combustion chamber is clean.
• the display is on standby (date and time).
SCREW FEEDER LOADING.
If the pellet hopper empties, press the + and - keys together to fill the screw feeder.
This must be done before igniting the stove again if it has shut down due to running out of pellets.
It is normal for a few pellets to be left in the hopper, which the screw feeder is not able to pick up.
IGNITION
Automatic ignition
Hold the 0/1 key down for two seconds with the stove on standby to start the ignition procedure. The word Start appears on
the display for a few minutes (ignition does not take a preset time: it is automatically shortened if the electronics detect that
certain tests are passed). The flame appears after about five minutes. It is normal for a little smoke to be seen in the
combustion chamber before the flame appears. Start remains on the display until the flame is stable.
Manual ignition
At temperatures of less than 3°C (too low for the heating element to glow) or if the heating element is temporarily out of
order, a firelighter may be used for ignition. Put a piece of well lit firelighter into the combustion chamber, close the door
and press the 0/1 button.
14