Specifications

12
INTERFACE:
OPERATION
Before ignition.
1st Ignition: contact your local TAC (technical assistance centre, for information consult www.edilkamin.com, or
phone toll-free number in Italy [phone]) to calibrate the insert according to the pellets available and
conditions of use.
The first few times the Insert is ignited there may be a slight smell of paint, which disappears rapidly.
Before ignition, check:
⇒ The insert has been installed correctly (see pages 8-9)
⇒ The power supply.
⇒ the door is closed.
⇒ The combustion chamber is clean.
⇒ The display shows standby (flashing date, power or temperature)
SCREW FEEDER LOADING.
When first used or if the pellet hopper empties completely, press the + and - keys on the remote control together for a
few seconds to fill the screw feeder; LOAD appears on the display when the keys are released.
This must be done before igniting the insert again if it has shut down due to running out of pellets.
It is normal for a few pellets to be left in the hopper, which the screw feeder is not able to pick up.
INSTRUCTIONS FOR USE 14
IGNITION
Automatic ignition
When the insert is on standby, press the 0/1 key (on the display-control panel or remote control) for 2 seconds to start
up the ignition procedure. The word Start appears on the display along with a countdown in seconds (1020). The
ignition procedure does not take a preset time: it is automatically shortened if the electronics detect that certain tests are
passed). The flame appears after about five minutes.
Manual ignition
At temperatures of less than 3°C (too low for the heating element to glow) or if the heating element is temporarily out
of order, a firelighter may be used for ignition.
Put a piece of well lit firelighter in the combustion chamber, close the door and press 0/1 on the display-control panel or
remote control.
OPERATING MODES
Power adjustment / Manual operation using the display-control panel
With the insert working, press the 0/1 key on the display-control panel. The word POWER appears on the display along
with the power level the insert is running at. It is possible to increase the power by pressing the 0/1 key repeatedly (from
POWER 1 to POWER 3).
Ventilation is adjusted automatically according to the power chosen.
Power adjustment / Manual operation using the remote control
With the insert working, press the Menu key on the remote control once. The word POWER appears on the display
along with the power level the insert is running at. It is possible to increase or decrease the power by pressing the + or -
keys (from POWER 1 to POWER 3).
DISPLAY-CONTROL PANEL
0/1 : Press for 2 seconds to turn on and off
Press briefly to change power level
(power 1 - power 2 – power 3) or temperature
REMOTE CONTROL (included)
0/1 : to turn on and off
Menu: to access the menu
+/- to increase / decrease
various settings