Technical data

33A
ENGLISH
COVERING ASSEMBLY
TINY
Fig. 7
It is possible, as shown in the figure, that at the joining
point between the ceramic and metal, the two components
will not be fully coplanar. To remedy this situation,
use the grub screws (g), screwing in the one on the side
where the ceramic is too close to the metal support.
ATTENTION!!! Do not screw the grub screw in too
tightly as doing so could break the ceramic. If there is
further need to adjust, but the grub screw turns
with difficulty, try loosening the grub screw opposite.
In the same way, fasten the other ceramic corner compo-
nent on the other side of the same side.
Once the side is full, start assembly of the second side
using the same procedure.
Fig. 8
Fasten the steel metal sides complete with ceramic corner
components (H) to the stove using the self-tapping screws
that were previously removed. The fastening holes are
accessible through the hole present on the ceramic corner
components.
LEFT TOP ASSEMBLY
Fig. 9
The left top is composed of a painted metal support (P)
and a ceramic component.
The support (P) is assembled to the stove bracket (S).
ATTENTION!!! make sure the ceramic support plate
(P) thus mounted is free to rotate to allow access to the
pellets lid (Q).
Fig. 10
The painted lid (I) is pre-assembled with pads (a, b, c, d)
to the plate (P).
Turning the screws securing the lid (I), it is possible to
adjust its height with respect to the plate (P).
Fig. 11
Then properly assemble the ceramic lid (L) using the
M6x8 screws with washer head (a1, b1, c1).
ATTENTION!!! Do not use the pads to secure
the ceramic piece.
ATTENTION!!! Make sure that the ceramic lid
(L) does not rub against the top when rotating and
that, once opened to load pellets, it does not close by
itself, falling.
Fig. 9
Fig. 10
*
Fig. 11
Fig. 7
Fig. 8
(g)
(g)
(H)
(I)
(a)
(b)
(d)
(c)
(L)
(a1)
(b1)
(c1)
(P)
(Q)
(S)
*
screws
screws
nuts
(S)
(P)
sk foglio aggiuntivo rivestimento Multilingua TINY-modificata x viti_cod 672590.qxp 16/09/2011 8.54 Pagina 8