Technical data

34
ENGLISH
COVERING ASSEMBLY
TINY
Fig. 13
Fig. 15
Fig. 17
(R)
(O)
(N)
RIGHT TOP ASSEMBLY
Fig. 13
The right top is composed of a painted metal support (N),
a ceramic component (O) and a painted closed lid (R) (if
the smoke outlet or hot air channelling pipe are used with
output from above, replace the closed lid (R) with the open
lid provided in the accessories bag).
On a large area, protected by a cloth or other similar to pre-
vent scratches, position the ceramic component (O). Then,
fasten the painted metal support (N) with the lid (R), remo-
ved from the stove, with 3 M6x8 screws with washer head.
Fig. 14
Turn the entire ceramic and supports (components N, R,O)
upside down, like in the figure.
Fig. 15
Position the whole piece (N, R, O), inserting it in the end
under the ceramic on the right side.
Fig. 16
Reassemble the stove component with the two previously
removed self-tapping screws, interposing 2 pads on the
top, in order to align the right and left tops.
To improve co-planarity, use pints on the right with the pad
(M), unscrewing them to lift the top right, screwing them
in to lower them.
Fig. 17
Use the same pins (M) under the left top to align the two
ceramic pieces, the right semi-top (U) and the left semi-top
(T).
Permanently adjust the position in height of the sides if
they are not the same level as the top level.
Fig. 18
Screw the threaded rod (V) in the stud (Y); insert the cera-
mic lid (X) in the threaded rod, insert the washer with hold
d.8 in the threaded rod and screw this all into the side
(T)
(U)
Fig. 14
Fig. 16
(V)
(Y)
(X)
Fig. 18
(M)
(M)
(M)
sk foglio aggiuntivo rivestimento Multilingua TINY-modificata x viti_cod 672590.qxp 16/09/2011 8.54 Pagina 9