Technical data

37
ENGLISH
COVERING ASSEMBLY
TINY
RIGHT TOP ASSEMBLY
Fig. 13
The right top consists of a painted metal support (N), a
ceramic component (O) and a closed, painted lid (R) (if
the smoke outlet or the hot air duct are used with a top
outlet, the closed lid (R) should be replaced with the open
lid included in the accessories bag).
Position the ceramic element (O) on a table, protecting it
with a cloth or other device so as to avoid that the paint
gets scratched; successively attach the glazed metallic sup-
port (N) with the lid (R), with n. 3 M6 x 8 screws and regu-
late the height.
Fig. 14
Turn over the ceramic and support assembly (components
N, R, O) as shown in the figure.
Fig. 15
Screw the other 2 pins (M) in the right part of the top into
their relative housings (s3 and s4).
Position the assembly (N, R ,O) inserting one end under
the ceramic component on the right side.
Fig. 16
The other end must be fixed, using two self-tapping screws
supplied, on the top, interposing 2 pads in order to align
the right top with the left top.
To improve alignment, use the pins with the pad (M) for
the right side, loosening them to raise the right side and
tightening them to lower it.
Fig. 17
Use the same pins (M) under the left top to align the two
ceramic components, right semitop (U) and left semitop
(T).
If the sides are not at the same level as the top, adjust their
height to the final, correct position.
Fig. 18
Screw the metallic boss (Y) to the threaded bracket (V).
Insert all of it in the ceramic cover (X); complete the
procedure by inserting the washer (K) Ø 24 with hole Ø 8.
Screw the unit to the side of the stove.
TINY
Fig. 13
Fig. 15
Fig. 17
(R)
(O)
(N)
(T)
(U)
Fig. 14
Fig. 16
(V)
(K)
(Y)
(X)
Fig. 18
(M)
(M)
(M)
             