Instructions

10
Chapter 4 Getting Started
This section provides an introduction to the web-based configuration utility, and covers the
following topics:
 Powering on the device
 Connecting to the network
 Power over Ethernet (PoE) considerations
 Starting the web-based configuration utility
4-1 Power
4-1-1 Connecting to Power
The switch is powered by the DC 100-240 V 50/60Hz internal high-performance power supply.
It is recommended to connect the switch with a single-phase three-wire power source with a
neutral outlet, or a multifunctional computer professional source.
Connect the DC power connector on the back panel of the switch to the external power
source with the included power cord, and check the power LED is on.
Power down and disconnect the power cord before servicing or wiring a switch.
Do not disconnect modules or cabling unless the power is first switched off. The
device only supports the voltage outlined in the type plate. Do not use any other
power components except those specifically designated for the switch.
Disconnect the power cord before installation or cable wiring.
Figure 5 Rear View showing DC Power Socket