User's Manual

IV-1-2. Wireless

The wireless page allows you to configure settings for your network camera’s

wireless connection. For Windows users, your wireless connection should

have been set up already using IP CAM Finder, though you can still use this

page to revise the settings if you need.

Mac users need to configure these settings manually since IP CAM Finder on

Mac will not set up your camera’s wireless connection. A quick guide to set up

your network camera’s wireless connection using a smartphone or a

computer is included below.

Mac users setting their network camera’s wireless connection for

the first time please ensure your network camera is connected to

your router/access point/switch via Ethernet cable.

You can also use the “wireless” page for Wi-Fi Protected Setup (WPS): to

either activate push-button WPS (the same effect as physically pushing the

hardware WPS button built into the camera), or PIN code WPS (using a PIN

code for verification between the two wireless devices for additional security.)