User's Manual

If you want to go back to previous step, please press „Back‟ button on the

bottom of this page.

3. Basic Setting

Here are descriptions of every setup items:

Wireless Module (1): Please click “Enable” to start using the wireless

function of this router, or select “Disable” to close

the wireless interface of this router.

Band (2): Please select a Bane type from the dropdown list of

„Band‟, It allows you to set the AP fix at 802.11b or

802.11g or 802.11n mode. You also can select B+G

or B+G+N mode to allow the AP select 802.11b,

NOTE: Some service providers use ‘DHCP’ (Dynamic Host

Configuration Protocol) to assign IP address to you. In this case, you

can choose ‘Cable Modem’ as Internet connection type, even you’re

using another connection type, like xDSL. Also, some cable modem

uses PPPoE, so you can choose ‘PPPoE xDSL’ for such cable modem

connection, even you’re using a cable modem.