User's Manual

Here are descriptions of every setup items:

Host Address (1): Input the IP address of the remote host you wish to

initiate a management access.

Port (2): You can define the port number this router should

expect an incoming request. If you’re providing a

web service (default port number is 80), you should

try to use other port number. You can use the default

port setting ‘8080’, or something like ‘32245’ or

‘1429’. (Any integer between 1 and 65534)

Enabled (3): Select the field to start the configuration.

When you finish with all settings, click ‘Apply’, and you’ll see the

following message displayed on web browser:

Press ‘Continue’ to save the settings made and back to web management

interface; press ‘Apply’ to save the settings made and restart the router so

the settings will take effect after it reboots.