User's Manual

ESSID (3): This is the name of wireless router. You can type any

alphanumerical characters here, maximum 32

characters. ESSID is used to identify your own

wireless router from others when there are other

wireless routers in the same area. Default SSID is

‘default’, it’s recommended to change default ESSID

value to the one which is meaningful to you, like

myhome, office_room1, etc.

Channel Number (4): Please select a channel from the dropdown list of

‘Channel Number’, available channel numbers are

1 to 13 for European countries, 1 to 11 for USA. You

can choose any channel number you want to use,

and almost all wireless clients can locate the

channel you’re using automatically without any

problem. However, it’s still useful to remember the

channel number you use, some wireless client

supports manual channel number select, and this

would help in certain scenario when there is some

radio communication problem.

Associated Clients (5): Click ‘Show Active Clients’ button, then an

“Active Wireless Client Table” will pop up. You can

see the status of all active wireless stations that are

connecting to the access point.

NOTE: If you don’t have special reason to limit the type of allowed

wireless client, it’s recommended to choose ‘2.4 GHz (B+G+N) to

maximize wireless client compatibility.

NOTE: For 802.11b and 802.11g mode, the signals can be transmitted

only by antenna 1 (The antenna in the right side of the rear panel).

For 802.11n mode: The router is operating in a 1T2R Spatial

Multiplexing MIMO configuration. 1 antenna is for signal transmitting

and 2 antennas are for signal receiving.