Owner manual

5
3. InstallADSLRouter

Step1.ConnecttheADSLLine
UsethesuppliedRJ‐11telephonecable,connecttherouterfromtheADSLporttoyourtelephonesocket
withanADSLmicrofilterpluggedin.

Step2.ConnecttheroutertoyourLANnetwork
ConnecttheroutertoyourPC,huborswitchbyattachedtheEthernetcabletotheLANportofthe
router.




Step3.ConnectthePowerAdaptertotheRouter
Connectthepoweradaptertothepowerjackontherearpaneloftherouterandswitchonthepower.

Step4.ChecktheADSLLEDlightstatus
PleasechecktheADSLLEDonthefrontpanel.ThislightindicatesthestatusofyourADSLbroadband
throughyourtelephoneline.Ifthelightisonsolid,youcancontinuethesetup.However,ifthelightis
flashing,thereisnobroadbandlinebeingdetected.Therefore,pleasecallyourInternetServiceProvider
(ISP)andinformthemabouttheflashingADSLlight.

Step5.Firewallsettings.
Pleaseturnoffallpersonalfirewallbeforeyoucontinuethesetupastheymightblockthe
communicationofyourPCandtherouter.


Note：Youmustusethepoweradaptershippedalongwiththerouter,doNOTuseanyotherpower
adapterfromothersources.



