- Edimax Broadband Router User's Manual

Once you have configured your PCs to obtain an IP address automatically, the router’s DHCP server will automatically

give your LAN clients an IP address. By default the Broadband Router’s DHCP server is enabled so that you can obtain

an IP address automatically. To see if you have obtained an IP address, see Appendix A.

Note: Please make sure that the Broadband router’s DHCP server is the only DHCP server available on your LAN. If

there is another DHCP on your network, then you’ll need to switch one of the DHCP servers off. (To disable the

Broadband router’s DHCP server see chapter 2 LAN Port)

1) Once your PC has obtained an IP address from your router, enter the default IP address 192.168.2.1 (broadband

router’s IP address) into your PC’s web browser and press <enter>

The login screen below will appear. Enter the “User Name” and “Password” and then click <OK> to login.

Note: By default the user name is “admin” and the password is “1234”. For security reasons it is recommended that you

change the password as soon as possible (in General setup/system/password, see chapter 2)

2) The HOME page screen below will appear. The Home Page is divided into four sections, Quick Setup Wizard,

General Setup, Status Info and System Tools.

Quick Setup Wizard (Chapter 1)

Select your Internet connection type and then input the configurations needed to connect to your Internet Service

Provider (ISP).

General Setup (Chapter 2)

This section contains configurations for the Broadband router’s advance functions such as: Address Mapping, Virtual

Server, Access Control, Hacker Attack Prevention, DMZ, Special applications and other functions to meet your LAN

requirements.

Status Info (Chapter 3)

In this section you can see the Broadband router's system information, Internet Connection, Device Status, System Log,

Security Log and DHCP client information.