User guide

28
III. Browser Based Configuration Interface
Once you have setup the access point in its desired operating mode as
detailed in II. Quick Setup, you can further configure the settings of the access
point anytime using the browser based configuration interface.
Note: You may need to modify the IP address of
your PC or Macintosh before you can access the
browser based configuration interface.
This is because the access point’s default IP address
192.168.2.1 may not be in the same IP address
subnet as your network. In this case, you need to
modify the IP address of your PC or Macintosh to
192.168.2.10. For guidance on how to do this,
please see Appendix IV-1. Configuring your IP
Address.
To access the browser based configuration interface, please enter the access
point’s default IP address “http://192.168.2.1” into the URL bar of a web
browser.
Note: For your reference, the access point’s default
IP address, username and password are all
displayed on the product label on the underneath
of the device, as shown below.