User guide

44
Note: In repeater mode, this device will
demodulate the received signal, check the
noise level, then modulate and amplify the
signal again. The output power of this
mode is the same as that of WDS and
normal AP mode.
Band
Please select the wireless band you wish to
use. By selecting different band settings,
you’ll be able to allow or deny devices using
certain bands.
If you select 2.4GHz (B), 2.4GHz (N), or
2.4GHz (G), only devices using the wireless
band you select (802.11b, 802.11n, or
802.11g) will be able to connect to this
device.
If you select 2.4GHz (B+G), then only
devices using the 802.11b and 802.11g
bands will be able to connect to this device.
If you want to allow 802.11b, 802.11g, and
802.11n devices to connect to this device,
select 2.4GHz (B+G+N).
MAIN SSID
Please input the ESSID (the name used to
identify this wireless access point) here. You
can input up to 32 alphanumerical
characters. Please note that the ESSID is
case sensitive.