User guide

47
Enable WPS
Check this box to enable or disable WPS.
Wi-Fi Protected
Setup
Information
WPS Status
Displays WPS status. If data encryption
settings for this access point have never
been set, “unConfigured” will be shown
here. If data encryption settings have been
set, “Configured” will be shown here.
Self PIN Code
This is the WPS PIN code of this access
point. This code is used when you need to
build a wireless connection by WPS with
other WPS-enabled wireless devices.
SSID
Displays the SSID (ESSID) of this access
point.
Authentication
Mode
The wireless security authentication mode
of this access point will be shown here. If
you don’t enable the security functions of
the access point before WPS is activated,
the access point will automatically set the
security to WPA (AES) and generate a
passphrase key for WPS connection.
Passphrase Key
Shows the WPA passphrase here, though all
characters will be replaced by asterisks for
security reasons. If encryption is not set on
this access point, this field will be blank.
Device
Configuration
Config Mode
There are “Registrar” and “Enrollee” modes
for the WPS connection. When “Registrar”
is enabled, the wireless clients will follow
the access point’s wireless settings for WPS
connections. When “Enrollee” mode is
enabled, the access point will follow the
wireless settings of wireless client for WPS
connections.
Configure via
Push Button
Click “Start PBC” to start Push-Button style
WPS setup. This access point will wait for
WPS requests from wireless clients for 2
minutes. The “WLAN” LED on the access
point will stay on for 2 minutes while this
access point waits for incoming WPS
requests.
Input Client PIN
Please input the PIN code of the wireless