I O N A L A N P O F E S S R L Gigabit Ethernet Adapter 64/32bit 66/33MHz PCI Gigabit Adapter EN-9210TX-64 User’s Manual
FCC COMPLIANCE STATEMENT This equipment has been tested and found to comply with the limits of a Class B computing devices, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
11 Introduction Thanks you for purchasing our Gigabit Fast Ethernet Adapter. This guide is to provide the installation and usage of this adapter for network installers and users. The Gigabit network adapter complies to 32/64 bit PCI specification and supports half/full duplex feature which can double network speed.
22 Features & Specifications (1) Features & Benefits y Supports 64/32-bit, 66/33MHz PCI Bus Master for high performance and low processor utilization. y Complies with the IEEE 802.3 CSMA/CD, 1000BaseT, 100BaseTX and 10BaseT standard. y Full duplex design to double the performance to 20Mbps/200Mbps/2000Mbps. y One RJ-45 connector for 1000Mbps, 100Mbps or 10Mbps network speed. y Support Auto-negotiation function. • Auto-setups IRQ and I/O address.
(2) Technical Specification y Topology : Star y Connector : RJ-45 y Standard : IEEE 802.3 10BaseT IEEE 802.3u 100BaseTX IEEE 802.3ab 1000BaseT y Transmission Rate : 10Mbps or 20Mbps 100Mbps or 200Mbps 1000Mbps or 2000Mbps y Hardware Required : IBM compatible PC with available PCI slot ( PCI 2.1/2.
33 Installation (1) Hardware Installation To insert the network adapter into your PC, follow the steps bellow : 1. Turn off the computer and remove its cover. 2. Insert the adapter into a PCI slot. 3. Secure this adapter to the rear of the computer chassis and put back the computer cover. 4. Connect the adapter to the network using twistedpair cable. (2) Driver Installation Use the drivers supplied by the diskette included in this product. For detail description, please execute the readme.
44 Trouble-shooting If you experience any problems with the adapter, first make sure the appropriate driver is loaded, the proper cable is connected to the adapter port and the hub/switch complies with the adapter specification, such as 10Mbps 10BaseT, 100Mbps 100BaseTX and 1000Mbps 1000BaseT, then check the LED. The adapter provides three LEDs to indicate network status. 10 Link/Activity The LED indicates if the 10Mbps UTP has been LINK ok or not.
TRADEMARKS Copyright 2001/2002 by the manufacturer of this product. No part of this manual may be reproduced, transcribed, stored in a retrieval system, translated into any language or computer language without the prior written consent of the manufacturer. All brand and product names are trademarks and/or registered trademarks of their respective companies.
