User Manual

5
I-6. Console/HyperTerminal
The controller can be configured via the “Console” port located on the access
point’s side panel using a terminal or a PC-based terminal-emulation program
(e.g. HyperTerminal).
Use a DB9 straight cable to connect the Console (RS-232 serial port) of the
APC500 and the RS-232 serial port of a terminal or PC.
Use the following configuration settings for terminal-emulation programs:
Baud Rate
115200
Data
8 bit
Parity
None
Stop
1 bit
Flow Control
None
The console cable pin definition is compatible with Cisco console
cables.