User Manual

4. Hardware Installation

4.1 Before You Start…

In MAC operating systems, you need to install the device drivers first (see next chapter)

and then perform the hardware installation steps below

4.2 Hardware Installation

Install the USB ADSL Modem by following these steps with the PC running:

1. Insert the rectangular end of a USB cable into the USB port of your PC.

2. Insert the square end of the USB cable into the USB port pf the USB ADSL Modem.

In Windows

operating systems, the USB ADSL Modem will be detected and the “Found

New Hardware Wizard” will be displayed on the PC’s screen. Proceed with the software

installation in the next section, using the operating system appropriate to you.