Installation guide

Product Introduction
Thank you for purchasing an Edimax product. This router is a cost-effective
router, an ADSL2+ modem, Ethernet network switch and wireless access
point (for wireless model only). You can surf the Internet and share the
connection through the Edimax router without investing in other devices.
This router can support downstream transmission rates of up to 24Mbps and
upstream transmission rates of up to 1Mbps. It supports PPPoA (RFC 2364 -
PPP over ATM Adaptation Layer 5), RFC 1483 encapsulation over ATM
(bridged or routed), PPP over Ethernet (RFC 2516), and IPoA (RFC1577) to
establish a connection with ISP. The product also supports VC-based and
LLC-based multiplexing.
With the web management interface, users can easily configure the various
functions of the router including DHCP server, NAT, virtual server, DMZ,
access control, IP filter, PPTP/IPSec/L2TP pass-through, DDNS, UPnP, and
Wireless.
1. Minimum Requirements
The following devices are necessary to configure the ADSL2+ Router:
z A PC with an Ethernet Adapter (required) and a Web-Browser (Internet
Explorer 4.0 or higher)
z RJ-45 Ethernet crossover cable
z RJ-11 Phone Line
2. Product Package
This package contains the following components:
 One ADSL2+ Router (Annex A or B)
 One Dipole Antenna (only for AR-7084gA) or Three Dipole
Antennas (only for AR-7084MgA)
 One Power Adapter
 One RJ-45 Ethernet Cable (100 cm)
 One RJ-11 Telephone Line (180 cm)
 One Quick Installation Guide
 One CD-ROM (Including the Setup Wizard, QIG and User’s Manual)
3. Install ADSL Router
Step 1. Connect the ADSL Line
Connect the router from the WAN port to your telephone socket with micro
filter plugged in through the supplied RJ-11 telephone line.