User Manual

User Manual
Field
Description
VCI
The virtual channel between two points in an ATM network,
ranging from 32 to 65535 (1 to 31 are reserved for known
protocols)
Encapsulation
You can choose LLC and VC-Mux.
Channel Mode
You can choose 1483 Bridged, 1483 MER, PPPoE, PPPoA, 1483
Routed or IPoA.
Enable NAPT
Select it to enable Network Address Port Translation (NAPT)
function. If you do not select it and you want to access the Internet
normally, you must add a route on the uplink equipment.
Otherwise, the access to the Internet fails. Normally, it is enabled.
Enable IGMP
You can enable or disable Internet Group Management Protocol
(IGMP) function.
IP Protocol
Select this interface support ipv4/ipv6, ipv4 or ipv6.
PPP Settings
User Name
Enter the correct user name for PPP dial-up, which is provided by
your ISP.
Password
Enter the correct password for PPP dial-up, which is provided by
your ISP.
Type
You can choose Continuous, Connect on Demand or Manual.
Idle Time (min)
If set the type to Connect on Demand, you need to enter the idle
timeout time. Within the preset minutes, if the router does not
detect the flow of the user continuously, the router automatically
disconnects the PPPoE connection.
WAN IP Settings
Type
You can choose Fixed IP or DHCP.
 If select Fixed IP, you should enter the local IP address, remote IP
address and subnet mask.
 If select DHCP, the router is a DHCP client, the WAN IP address is
assigned by the remote DHCP server.
Local IP
Address
Enter the IP address of WAN interface provided by your ISP.
Netmask
Enter the subnet mask of the local IP address.
Unnumbered
Select this checkbox to enable IP unnumbered function.
IPv6 WAN
Setting
Set ipv6 wan setting if this interface support ipv6
Address Mode
Select this interface support Slaac or Static to generate wan ipv6