User Manual

User Manual
Field
Description
addresses.
Enable DHCPv6
Client
Enable or disable dhcpv6 client on this interface, if enable, user can
specify if the dhcpv6 client request Address or request Prefix.
Add
After configuring the parameters of this page, click it to add a new
PVC into the Current ATM VC Table.
Modify
Select a PVC in the Current ATM VC Table, then modify the
parameters of this PVC. After finishing, click it to apply the settings
of this PVC.
Delete
Select a PVC in the Current ATM VC Table, and then click Delete to
delete it
Current ATM
VC Table
This table shows the existed PVCs. It shows the interface name,
channel mode, VPI/VCI, encapsulation mode, local IP address,
remote IP address and other information. The maximum item of this
table is eight.
After proper settings, click Add and the following page appears.
Click in the PPPoE mode, the page shown in the following figure appears. In this page,
you can configure parameters of this PPPoE PVC.