User Manual

User Manual
Field
Description
 If you select Usual Service Name, the corresponding parameter has
the default settings.
 If you select User-defined Service Name, you need to enter the
corresponding parameters.
Protocol
Choose the transport layer protocol that the service type uses. You can
choose TCP or UDP.
WAN
Setting
You can choose Interface or IP Address.
WAN
Interface
Choose the WAN interface that will apply virtual server.
WAN Port
Choose the access port on the WAN.
LAN Open
Port
Enter the port number of the specified service type.
LAN IP
Address
Enter the IP address of the virtual server. It is in the same network
segment with LAN IP address of the router.
4.2.2.3. ALG
Click ALG in the left pane, the page shown in the following figure appears. Choose the
NAT ALG and Pass-Through options, and then click Apply Changes.
4.2.2.4. NAT Exclude IP
Click NAT Exclude IP in the left pane, the page shown in the following figure appears.