User Manual

User Manual
Click the Usual Application Name drop-down menu to choose the application you want
to setup for port triggering. When you have chosen an application the default Trigger
settings will populate the table below.
If the application you want to setup isn’t listed, click the User-defined Application Name
radio button and type in a name for the trigger in the Custom application field. Configure
the Start Match Port, End Match Port, Trigger Protocol, Start Relate Port, End Relate
Port, Open Protocol and Nat type settings for the port trigger you want to configure.
When you have finished click the Apply changes button.
4.2.2.6. FTP ALG PORT
Click FTP ALG PORT in the left pane, the page shown in the following figure appears.
This page is used to configure FTP Server ALG and FTP Client ALG ports.
4.2.2.7. Nat IP Mapping
Click Nat IP Mapping in the left pane, the page shown in the following figure appears.