User Manual

User Manual
The following table describes the parameters and buttons of this page.
Field
Description
IP QoS
Select to enable or disable IP QoS function. You need to enable IP QoS if
you want to configure the parameters of this page.
QoS
Policy
You can choose stream based, 802.1p based or DSCP based.
Schedule
Mode
You can choose strict prior or WFQ (4:3:2:1).
Source IP
The IP address of the source data packet.
Source
Mask
The subnet mask of the source IP address.
Destinati
on IP
The IP address of the destination data packet.
Destinati
on Mask
The subnet mask of the destination IP address.
Source
Port
The port of the source data packet.
Destinati
on Port
The port of the destination data packet.
Protocol
The protocol responds to the IP QoS rules. You can choose TCP, UDP, ICMP
or TCP/UDP.
Physical
Port
The LAN interface responds to the IP QoS rules.
Set
priority
The priority of the IP QoS rules. P0 is the highest priority and P3 is the
lowest.
802.1p
You can choose from 0 to 7.
delete
Select a row in the QoS Rule list and click it to delete the row.
delete all
Select all the rows in the QoS Rule list and click it to delete the rows.
4.2.4. CWMP
Choose Advanced > CWMP, the page shown in the following page appears. In this page,
you can configure the TR-069 CPE.