Instructions

5
4. Click Next and you can configure the LAN Interface Setup. This page is used to configure the
parameters for local area network which connects to the LAN port of your Access Point. Here you
may change the setting for IP address, subnet mask, DHCP, etc.
5. Click Next and you can configure the WAN Interface Setup. This page is used to configure the
parameters for Internet network which connects to the WAN port of your Access Point. Here you
may change the access method to static IP, DHCP, PPPoE by click the item value of WAN Access
type.
6. Click Next and then the following page will pops up. Generally, the default selection is ok.