Instructions

59
Step 6. You'll go back to the Ethernet Properties box, please click OK .
2. I can’t open the browser based configuration interface.
a. Make sure the connection of WAN and LAN port(s) is correct.
b. Ensure that your Ethernet cable with internet connectivity is plugged into the
WAN port of the router rather than a LAN port.
c. Ensure that your wireless device is connected to the LAN port(s) of the router.
d. Make sure you enter the correct IP address (192.168.2.1) to log in.
e. Make sure the IP address of your computer is configured as Obtain an IP
address automatically and Obtain DNS server address automatically.
f. Use another web browser to log in again.
g. Reset the router to factory default settings and try again.
3. How do I reset my device to factory default settings?
a. To reset the device back to its factory default settings, press and hold the
WPS/Reset button for over 10 seconds, until the power LED begins to flash.
Please wait a few minutes for the product to restart. When the device restarts,
all settings will be reset. Default settings are displayed on the product label on
the back of the device.
Router Login
Enter this URL in a web browser to run iQ Setup or
configure advanced settings. You must be
connected to the device by Wi-Fi or Ethernet
cable.
Username/Password
This is the default username and password to
access the browser based configuration interface
when you go to the “Router Login” URL (above).
Wi-Fi Network
Name
This is the default Wi-Fi network name for the
device. Search for this name (SSID) and connect to
it in order to access the “Router Login” URL
(above).
MAC
A MAC address is unique to every device and is
used for identification within a network. Your
device’s unique MAC addresses are displayed
here.
PIN CODE
This is your device’s PIN code for Wi-Fi Protected
Setup (WPS) for each wireless frequency.