User Manual

6
II Hardware Installation
II-1 Router/PoE Switch
1. If you need to, remove the cap from the underside of the device. This
creates extra space for your cables to pass through.
2. Connect a router or a PoE switch to the device’s LAN 1 port using an
Ethernet cable.
3. Power up the device:
a) If router is used, connect the power adapter to the device’s 12V DC
port and plug the power adapter into a power supply; or
b) If PoE (Power over Ethernet)
switch is used, make sure the
Ethernet cable is connected to
LAN1 port from the switch.
The device will be powered by
the PoE switch.
Do not use the power adapter if
you are using a PoE switch.
4. Connect a local network client or switch to the device’s LAN 2 port as
required.