User Manual

169
Auto Pilot
Interval
Specify a frequency for how often the auto channel setting
will check/reassign the wireless channel. Check/uncheck the
“Change channel even if clients are connected” box according
to your preference.
Channel
When Auto Pilot is disabled, select a channel (1-11) manually.
Channel
Bandwidth
Set the channel bandwidth or use Auto (automatically select
based on interference level).
BSS
BasicRateSet
Set a Basic Service Set (BSS) rate: this is a series of rates to
control communication frames for wireless clients.
These settings are for experienced users only. Please do not change any of the
values on this page unless you are already familiar with these functions.
Changing these settings can adversely affect the performance of your
access points.
Advanced Settings
Contention
Slot
Select “Short” or “Long” – this value is used for contention
windows in WMM (see X-6-7 WMM).
Preamble
Type
Set the wireless radio preamble type. The preamble type in
802.11 based wireless communication defines the length of
the CRC (Cyclic Redundancy Check) block for communication
between the access point and roaming wireless adapters. The
default value is “Short Preamble”.
Guard
Interval
Set the guard interval. A shorter interval can improve
performance.
802.11n
Protection
Enable/disable 802.11n protection, which increases reliability
but reduces bandwidth (clients will send Request to Send
(RTS) to access point, and access point will broadcast Clear to
Send (CTS), before a packet is sent from client.)
CE Adaptive
The measurement procedure follows clause 5.3.11.2.2 of the
ETSI EN 300 328 V1.8.1
DTIM Period
Set the DTIM (delivery traffic indication message) period value
of the wireless radio. The default value is 1.
RTS
Threshold
Set the RTS threshold of the wireless radio. The default value
is 2347.