User Manual

310
- <Parameter>
pd Set the one of wired ports.
pse Set the two of wired ports.
{speed} 10 Set to 10Mbps.
100 Set to 100Mbps.
{duplex} full Set to full duplex
half Set to half duplex.
{state} disable Disable the flow control.
enable Enable the flow control.
- <Default configuration>
speed:auto, flowctl:enable
(The same configuration on all ports)
- <Command mode>
Immediate Mode, Edit Mode
- <Compatible Products>
CAP1300
- <Examples>
# lan ether port pd speed speed auto flowctl enable
# lan ether port pse speed speed 100 duplex full flowctl disable
# lan ether port pse speed speed 1000 duplex full flowctl enable
lan ether port {pd ｜ pse} vlan mode
Set the wired ports of VLAN.
<The syntax of the command>
lan ether port {pd｜pse} vlan mode {tagged｜untagged} vlan (vlanid)
- <Parameter>
pd Set the one of wired ports.
pse Set the two of wired ports.
(vlanid) Set the VLAN ID. (1~4094)
- <Default configuration>
Vlanid : 1, untagged
(The same configuration on all ports)
- <Command mode>
Immediate Mode, Edit Mode
- <Compatible Products>
CAP1300
- <Examples>
# lan ether port pd vlan mode untagged vlan 404
# lan ether port pse vlan mode tagged vlan 403
lan ether show status
Show the status of the VLAN wired ports.
<The syntax of the command>
lan ether show status
- <Parameter>
NA