User Manual

18
IV. Browser Based Configuration Interface
The browser-based configuration interface enables you to configure the
access point’s advanced features. The CAP300 features a range of advanced
functions such as MAC filtering, MAC RADIUS authentication, VLAN
configurations, up to 16 SSIDs and many more. To access the browser based
configuration interface:
1. Connect a computer to your access point using an Ethernet cable.
2. Enter your access point’s IP address in the URL bar of a web browser. The
access point’s default IP address is 192.168.2.2.
3. You will be prompted for a username and password. The default
username is “admin” and the default password is “1234”, though it was
recommended that you change the password during setup (see II-2. Basic
Settings).
If you cannot remember your password, reset the access point
back to its factory default settings. Refer to I-5. Reset
4. You will arrive at the “System Information” screen shown below.