Quick Installation Guide

Connect computers or other network devices to these ports using an

Ethernet cable.

c. Power Port

Connect the included 5V DC power adapter here.

d. WPS/Reset Button

Press and hold this button for 2 seconds to activate the WPS function. Press

and hold this button for 10 seconds, until the PWR LED starts flashing, to

reset the wireless bridge to factory default settings.

Quick Installation

There are two ways you can quickly setup your wireless bridge - using the WPS

button or using iQ Setup on your computer.

I. WPS Button Setup

Note: If your root network access

point/router does not have a WPS button

or if you encounter difficulties establishing

a WPS connection, please refer to II. iQ

Setup as an alternative.

1. Plug the power adapter into the device’s 5V power port, and plug the

adapter into a wall socket. The PWR LED will light up as on when the device

is ready.

2. Press and hold the WPS button on the wireless bridge for 2 seconds to

activate the WPS function. The WLAN LED should flash slowly (two seconds

on, two seconds off) to indicate that WPS is in progress.