Quick Installation Guide

4. A WPS connection will now be established between your wireless bridge

and root network router/access point within two minutes. The WLAN LED

will stop flashing, and display on to indicate a successful connection. The

WLAN LED will remain on for 5 minutes.

Note: If the WPS function on your wireless

bridge timed out after 2 minutes, before

you activated WPS on your router/access

point, then please return to step 2 and try

again.

Your wireless bridge is now configured and ready for use with your wired

network device, such as smart TV, Blu-ray player or games console. Please see

Hardware Installation for guidance on using the wireless bridge with your

network device.

II. iQ Setup

1. Connect one end of an Ethernet cable (included in the package contents) to

the Ethernet port on your computer. Connect the other end to an LAN port

on the wireless bridge.

2. Plug the power adapter into the device’s 5V power port, and plug the

adapter into a wall socket. The PWR LED should light up.

Note: Before you use the wireless bridge, please

make sure your computer is set to use a dynamic IP

address. This is a simple procedure, and step by

step instructions for how to do this, can be found in

the user manual.