Quick Installation Guide

5. Driver Installation
Insert the installation CD into your CDROM drive, the setup
programs will appear, select “EN-9230TX-32” then click on the
“Product Driver” to install the driver, or you can click on the
“Browse CD” to find other OS drivers on the CD.
6. Trouble-Shooting
If you experience any problems with the adapter, please make
sure the appropriate driver is loaded, the proper cable is
connected to the adapter port and the Hub/Switch complies with
the adapter specification, such as 10Mbps 10BaseT, 100Mbps
100BaseTX and 1000MbpsTX, then check the LED.
The adapter provides LED to indicate network status.
Link/Activity
The LED indicates if the UTP has been LINK ok or not. When the
light is OFF, it indicates that the UTP port has not been connected
or Link not ok, when the light is ON, it indicates that the UTP port
Link is ok, when the light is BLINKING; it indicates that there is
traffic flow on the network which the adapter is connected to.