Quick Installation Guide

4
4. Installation
1. Hardware Installation: Hold the Card label up and insert the card into the notebook
PCMCIA / Cardbus slot with 68 pin connector facing the notebook.
2. Software Installation: The drivers and utilities are supplied by the CD-ROM included
in this product. For a detailed description, please see the description on the CD
Rom.
5. Trouble Shooting
If you are experiencing any problems with the PC Card, first make sure the appropriate
driver is loaded, the proper cable is connected to the PC card, and the hub is on and
working and then check the LED.
6. LEDs indication
EP-4103DL
1. 10M: When the light is on, it indicates that the 10Mbps connection is established,
when the light is blinking, it indicates that the packets are transmitting.
2. 100M: When the light is on, it indicates that the 100Mbps connection is established,
when the light is blinking, it indicates that the packets are transmitting.
EP-4203DL
1. 10M/100/1000M : When the light is off, it indicates that the 10Mbps UTP connection
is established, when the light is Green, it indicates that the 100Mbps Fast Ethernet
connection is established, when the light is Amber, it indicates that the 1000Mbps
Ethernet connection is established
2. Link/Activity: The Link/Activity LED indicates the network connection status, when
the light is OFF, it indicates that the 10/100Mbps port has not been connected or
linked, when the light is ON, it indicates that the 10/10Mbps port is connected, when
the light is blinking, it indicates that there is traffic flow on the network which the
adapter is connected to.