ES-3305P / ES-3308P / ES-3316P Quick Installation Guide 09-2012 / v1.
COPYRIGHT Copyright Edimax Technology Co., Ltd. all rights reserved. No part of this publication may be reproduced, transmitted, transcribed, stored in a retrieval system, or translated into any language or computer language, in any form or by any means, electronic, mechanical, magnetic, optical, chemical, manual or otherwise, without the prior written permission from Edimax Technology Co., Ltd. Edimax Technology Co., Ltd.
PRODUCT INTRODUCTION Model: ES-3305P: 5 Port Fast Ethernet Desktop Switch ES-3308P: 8 Port Fast Ethernet Desktop Switch ES-3316P: 16 Port Fast Ethernet Desktop Switch Package Contents Before you start using this switch, please check if there is anything missing in the package, and contact your dealer to claim the missing item(s): Fast Ethernet Desktop switch User manual Power Adapter Front Panel ES-3305P PWR LED LNK/ACT LEDs 1 - 5 ES-3308P PWR LED LNK/ACT LEDs 1 - 8 ES-3316P PWR LED LNK/ACT LEDs
LED Status: LED Name Light Status PWR On Off On LNK/ACT Off Flashing Description Switch is on Switch is off Corresponding port is connected Corresponding port is not connected Corresponding port is active and transferring /receiving data.
- Do not position the unit near any heating source such as a heater, radiator or in direct exposure to sun. - Take care to ensure the unit does not come into contact with water. Consider using a dehumidifier to reduce humidity and prevent moisture entering the unit. Connecting to network devices The RJ-45 ports on the switch support Auto-MDI/MDI-X which allows both straight-through or cross-over type cables to connect this switch to a workstation or hub.
TROUBLESHOOTING 1. Power LED is not lit Check if the power cord is properly connected to the external power adapter and the power source. Make sure the DC power jack is firmly plugged into the power socket of the switch. 2. Link/Activity is not lit when connected to devices - Ensure that the network device attached to the switch is switched on. - Check the network cable; ensure it is properly connected to the switch and the network device.
Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class A/B digital device, pursuant to Part 15 of FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
