Datasheet

Key Features

QoS with Four Priority Queues

The QoS (Quality Of Service) feature provides four internal queues to support four different classifications of

traffic. High priority packet streams experience less delay inside the switch, which supports lower latency for

certain delay-sensitive traffic. it can classify the packet as one of the four priorities according to 802.1p

priority tag, DiffServ and/or IP TOS. The QoS operate at full wire speed. The actual scheduling at each

egress port can be based upon a strict priority, weighted round robin or a mix of both.

Port Mirroring

This mechanism helps track network errors or abnormal packet transmission without interrupting the flow of

data. Allow ingress traffic to be monitored by a single port that is defined as mirror capture port. The mirror

capture port can be any 10/100 port, 10/100/1000 port. Mirroring multiple ports is possible but can create

congestion at the mirror capture port.

VLAN for Performance & Security

The VLAN feature in the switch offers the benefits of both security and performance. VLAN is used to isolate

traffic between different users and thus provides better security. Limiting the broadcast traffic to within the

same VLAN broadcast domain also enhances performance.

Isolated Group, Provide Secure for Certain Ports

The isolated group feature allows certain ports to be designated as protected. All other ports are non-isolated.

Traffic between isolated group members are blocked. Traffic can only be sent from isolated group to non-

isolated group.

Mac-based Trunking with Automatic Link Fail-over

Dynamic fail-over means packets will not get assigned to any trunk member port that has failed. If one of the

ports were to fail, traffic will automatically get distributed to the remaining active ports.

Trap Event for Exception Management

We use SNMP Trap mechanism to inform supervisor to know the instant abnormal status of the switch.

2 Dual Media for Flexible Fiber Connection

25, 26 dual media port are provided for flexible fiber connection. You can select to install optional transceiver

modules in these slots for short, medium or long distance fiber backbone attachment. Use of the SFP/GBIC

will disable their corresponding built-in 10/100/1000Base-T connections.

Build-in Web-base Management

Instead of using CLI interface, we provide a more convenient GUI for user. We just need to configure switch

via Web Browser. It is more quickly for user to familiar the method to control switch on the basis of this

design.

24 + 2 Ports Web Smart

Switch

Integrated 2 x SFP Module Ports

Fast Ethernet Web Smart Switch

ES-5224RS+

PAGE 1
Fast Ethernet Web Smart Switch 24 + 2 Ports Web Smart Switch ES-5224RS+ Integrated 2 x SFP Module Ports Key Features QoS with Four Priority Queues The QoS (Quality Of Service) feature provides four internal queues to support four different classifications of traffic. High priority packet streams experience less delay inside the switch, which supports lower latency for certain delay-sensitive traffic. it can classify the packet as one of the four priorities according to 802.
PAGE 2
Standard compliance IEEE 802.3 10Base-T / IEEE 802.3u 100Base-T / IEEE 802.3ab 1000Base-T / IEEE 802.3z 1000Base-X Ethernet, IEEE 802.3x flow control / IEEE 802.3 auto-negotiation / IEEE 802.1q VLAN Subscriber Interface 1-24 10/100Mbps Fast Ethernet ports. / 25,26 are Gigabit TP/ SFP Fiber auto sense Auto-Negotiation and Auto-MDIX Backpressure flow control for half duplex / 802.3x flow control for full duplex.