User Manual

25
mode.
AP Bridge-WDS
This mode is similar to “AP Bridge to
Multi-Point”, but the device is not in
bridge-dedicated mode, and will be able to
accept wireless clients.
III-3-1. AP
In access point (AP) mode the device acts as a wireless access point to a wired
Ethernet network for IEEE 802.11b/g/n wireless devices.
Band
Select the wireless band you wish to use for
the access point: 802.11b, 802.11g, 802.11n
or selected combinations of each. Only
wireless clients of the same band(s) as you
select will be able to connect.
MAIN ESSID
Specify an ESSID (the name used to identify
the access point) of up to up to 32
alphanumerical characters. Please note that
the ESSID is case sensitive.
Multiple ESSID
Click “Multiple ESSID” to open a new window
and assign up to four ESSIDs to this access
point. Please see the following page for more
details.
AP Isolation
When “Enabled”, wireless clients will be able
to access the Internet, but will not be able to
communicate with each other. This applies to
clients connected to the MAIN ESSID only.
Channel Number
Select a channel number for the access point.
Where possible, select a channel number