User Manual

44
You can change the password used to login to the browser-based
configuration interface here. It is advised to do so for security purposes.
If you change the administrator password, please make a note
of the new password. In the event that you forget this
password and are unable to login to the browser based
configuration interface, see II-2. Reset for how to reset the
access point.
Current Password
Enter your current password. The default
password is 1234.
New Password
Enter your desired new password here. You can
use any combination of letters, numbers and
symbols up to 20 characters.
Re-Enter
Password
Confirm your new password.
Please refer to IV-1. Configuring your IP address for more
information about changing the access point’s IP address.
IP Address
Specify an IP address here. This IP address will
be assigned to your access point, and will
replace the default IP address 192.168.2.2.
Subnet Mask
Input the subnet mask of the new IP address.
Gateway Address
Input the network’s gateway IP address.
The access point can be configured to act as a DHCP server for your network.
By default DHCP is disabled. Enable DHCP by selecting “Enable” in the field
“DHCP Server” of “Management IP” as detailed in the previous section.
DHCP Server
Select “Enabled” if you wish to use the DHCP
function of the access point, as detailed below.
Default Gateway
Specify the IP address of the default gateway of
your network here.
Start IP
Enter the start address of the IP range.
End IP
Enter the end address of the IP range.
Domain Name
Enter the domain name for your network
(optional).
Lease Time
Choose a lease time (the duration that every
computer can keep a specific IP address) of