Operation Manual

11
2-2 Connect to Wireless Access Point
After the driver is correctly installed, it will try to connect to any
unencrypted wireless access point automatically. If you want to
connect to a specific wireless access point, or the access point you
wish to connect uses encryption, you have to configure the wireless
network card and input required parameters, to get connected to
the wireless access point you wish to connect.
The current status of wireless connection will be displayed by
Edimax configuration utility icon:
Wireless connection is established, good signal reception.
Wireless connection is established, normal signal reception.
Wireless connection is established, weak signal reception.
Connection is not established yet.
Wireless network card is not detected.
There are two ways you can configure your wireless network card
to connect to wireless access point: using the Edimax configuration
utility and using built-in windows zero configuration utility.