ES-1008PH / ES-1008P GS-1008PH / GS-1008P Quick Installation Guide 07-2012 / v1.
COPYRIGHT Copyright Edimax Technology Co., Ltd. all rights reserved. No part of this publication may be reproduced, transmitted, transcribed, stored in a retrieval system, or translated into any language or computer language, in any form or by any means, electronic, mechanical, magnetic, optical, chemical, manual or otherwise, without the prior written permission from Edimax Technology Co., Ltd. Edimax Technology Co., Ltd.
PRODUCT INTRODUCTION Model no.
LED Definitions: LED Name Light Status PWR On Off On LINK/ACT Off Flashing PoE On Off Description Switch on and correctly powered Switch not powered or not correctly powered Port is connected Port is not connected Port is active and transferring/receiving data PoE on and powering PoE/PoE+ PoE is not activated Back Panel: Power Connector: Plug in the female connector of the provided power cord into this connector, and the male into a power outlet.
1. PRODUCT INSTALLATION There are two ways to install your switch, please select one that suits you. 2. Desktop Installation 1. Install the switch on a level surface that can support the weight of the unit and the relevant components, and attach the rubber feet to the bottom. The rubber feet cushion the switch and helps protect the case from scratches. 2. Plug the switch into an electrical source with the provided power cord. 3.
Troubleshooting 1. Power LED is not lit Check if the power cord is properly connected to the plug and the power outlet; make sure the power cord is firmly plugged into the power socket of the switch. 2. LINK/ACT LED is not lit when connected to devices Make sure the network device attached to the switch is turned on. Make sure the network cable is properly connected to the switch and the network device.
Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
