User manual

24

Chapter7:Troubleshooting

Ifyourpowerlineadaptershavedifficultycommunicatingwitheachother,trythe
followingprocedures:

• Trypowercyclingtheunitbyunplugging itfromtheelectricoutletfor10secondsand
pluggingitinagain.
• Holdthe“Group/Reset”buttondownfor10~15secondsoneachunit
youaretryingto
connect.Theunitswillresetandattempttoestablishaconnectionusingfactorydefault
settings.
• Trypluggingthepowerlineadapterintoanadjacentelectricoutlet.
• ThispowerlineadaptershouldnotbeusedonGFIprotectedelectricoutlets,assome
outletswillfilteroutthe
powerlinesignal.
• Thispowerlineadaptershouldnotbeusedinareaswithexcessiveheat.
• Certainflorescentorincandescentlightsarenoisesourcesthatcandegrade
performance.
• Ifyourbuildinghasmorethanonecircuitbreakerbox,yourpowerlineadaptersmaynot
beabletoestablishaconnectionacross
differentcircuitbreakerboxes.Insuchcases,try
establishingaconnectionacrossdifferentcircuitbreakerboxesbylinkingtwopowerline
adapterstogetherwithanEthernetcable.