Quick Installation Guide

III. FAQ

III-1. The PWR LED does not light up.

˙ Make sure that the Powerline Adapter is properly plugged into a

power outlet.

˙ Make sure the power outlet is active (working) by plugging another

electric device into it.

˙ Re-plug the Powerline Adapter to the power outlet again. If the Power

LED still fails to light up, then please contact your local dealer for

technical support.

III-2. The LAN LED does not light up.

˙ Make sure that the Ethernet cable is properly connected to the

Powerline Adapter’s Ethernet port.

˙ Make sure that the other end of the Ethernet cable is properly

connected to the Ethernet port on your computer.

˙ Make sure your computer LAN card is properly installed and

configured.

˙ Make sure your Cable/xDSL broadband access is working and

configured correctly.

˙ Try to plug a second Powerline Adapter into a nearby power outlet and

check whether the Ethernet LED lights up or not

˙ Press two Powerline Adapter’s button to creat a new network, then

check whether the Ethernet LED lights up or not

˙ Contact your local dealer for technical support if the Ethernet LED still

fails to light up after the above procedures.

Note: The device will enter standby/power-saving mode 5 seconds after the device

disconnected with Ethernet cable, and all LEDs will extinguish without any data

transfer. Right after the Ethernet cable connected to the device, the three LEDs

will flash simultaneously while the device is leaving the standby/power-saving

mode.