User Manual

18
IV. Browser Based Configuration Interface
In Managed AP mode some functions of the browser based
configuration interface are disabled. Please use Edimax Pro NMS
on your Controller AP to configure your Managed AP(s).
The multi-language browser-based configuration interface enables you to
configure the access point’s advanced features. The IAP1200 features a range
of advanced functions such as MAC filtering, MAC RADIUS authentication,
VLAN configurations, 802.11ac Wi-Fi, up to 32 SSIDs and many more. To
access the browser based configuration interface:
1. Connect a computer to your access point using an Ethernet cable.
2. Enter the access point’s IP address into the URL bar of a web browser. The
default IP is 192.168.2.2. If the AP is connected to a DHCP server, ensure
you use the correct address.
2. You will be prompted for a username and password. The default username
is “admin” and the default password is “1234”, though it was
recommended that you change the password during setup.
If you cannot remember your password, reset the access point
back to its factory default settings. Refer to I-5. Reset
3. You will arrive at the “System Information” screen shown below.