User Manual

87
V. Appendix
V-1. Configuring your IP address
The access point uses the default IP address 192.168.2.2. In order to access
the browser based configuration interface, you need to modify the IP address
of your computer to be in the same IP address subnet e.g. 192.168.2.x (x = 3 –
254).
The procedure for modifying your IP address varies across different operating
systems; please follow the guide appropriate for your operating system.
In the following examples we use the IP address 192.168.2.10 though you can
use any IP address in the range 192.168.2.x (x = 3 – 254).
If you changed the AP’s IP address, or if your gateway/router uses
a DHCP server, ensure you enter the correct IP address. Refer to
your gateway/router’s settings. Your computer’s IP address must
be in the same subnet as the AP Controller.
If using a DHCP server on the network, it is advised to use your
DHCP server’s settings to assign the AP a static IP address.