User manual

7
For use a Managed AP in an AP array, the access point will automatically
switch mode when an AP Controller is configured as described in Edimax Pro
NMS.
II-1. Initial Setup
1. Connect the IAP1200’s rear Ethernet port to a PoE switch (LAN port) using
an Ethernet cable.
2. Use a computer that’s connected to the LAN or connect to the IAP1200’s
front Ethernet port using an Ethernet cable.
3. Open a web browser and enter the access point’s IP address in the address
field. The default IP address is 192.168.2.2
Your computer’s IP address must be in the same subnet as the AP
access point.