User manual

4.3. Hardware Installation Procedure

1. Unpack the Internet Camera package and verify that all the items listed in the Chapter 2

are provided.

2. Connect the Internet Camera to your network by attached the network cable from the

switch/router to the UTP port of the Internet Camera.

3. Connect the power adapter to the Internet Camera and plug the power adapter to power

outlet. The Internet Camera will be powered on. When the Internet Camera is ready, the

Ready LED will light.

4. Make sure that you have installed correct VGA driver and DirectX 9.0 or above.

Note: It is highly recommended to use the power adapter shipped with the Internet Camera,

do NOT use any other power adapter from any sources.