IC-5150W Quick Installation Guide 12-2015 / v1.
包裝內容 IC-5150W 電源變壓器 CD 光碟片 安裝指南 網路線 壁架組 2 螺絲與壁虎
LED 指示燈號說明 LED 名稱 LED 燈色 說明 LED 狀態 本產品已啟動並已連接至雲端伺服 器 燈亮 電源 綠色 快速閃爍 本產品正在啟動 慢速閃爍 本產品正在啟動或未連接至雲端伺 服器 (約每秒閃 1 次) LAN Internet 綠色 橘色 燈亮 本產品已連接到區網 快速閃爍 LAN 埠資料傳輸中 慢速閃爍 (約每秒閃 1 次) WPS 功能已啟動 燈亮 已連接到網際網路 慢速閃爍 (約每秒閃 1 次) 未連接到網際網路 硬體安裝 請您按照本章節的說明,使用 Wi-Fi 無線網路連線,安裝並啟動 EdiLife 手機 App 來設定您的 IC-5150W,您也可以使用電腦,以有線網路連接 的方式來設定(詳情請參閱 CD 內附使用手冊)。 您可以在本產品底座標籤貼紙上找到產品獨有的 SSID,它會是如此標示 "EdiView.
1. 請將包裝內附的電源變壓器連接 至產品本體底部的電源連接埠, 並將插頭端插入電源插座。 2.
3. 請使用您的手機或平板,依您其作業系統至 Google Play 或 Apple App Store 搜尋〝 EdiLife〞App,然後下載並安裝。 4. iOS 用戶請在啟動 EdiLife 之前,先前往您 iPhone 的 Wi-Fi 設定,並連 接到您網路攝影機的 SSID (EdiView.Setup **),接著請前往步驟 7 5.
. Android 用戶請自可用的無線裝置清單中選擇您的無線網路攝影機 後,耐心稍待 App 建立連線。 若您未看到您想要連線的無線網路,請點擊右上角 的”重新整理” 圖示. 7.
8. 請從清單中選擇您的 Wi-Fi 無線網路,然後輸入您的無線網路密碼 後,再按 OK "確定"。 若您未看到您想要連線的無線網路,請點擊右上角 的”重新整理” 圖示. 9.
10. 安裝已完成。此時 IC-5150W 的綠色電源 LED 指示燈及橘色 Internet LED 燈應為恆亮狀態。現在您的 IC-5150W 網路攝影機應該已經出現在 EdiLife 的主頁畫面中,只要連線 Internet,您就隨時隨地點擊您清單中 的 IC-5150W,觀看其所拍攝的即時影像了。 您可以使用即時影像視窗下方的小圖示來配置您的 IC-5150W 設定 及功能。 11.
WPS 快速連線 WPS 按鍵是一個可快速且簡單,用來建立 IC-5150W 和您的無線分享器/ 無線 AP 之間安全無線連接的方法。 1. 按下無線分享器/無線 AP 的 WPS 按鍵,啟動 WPS 功能( 所需按壓時 間,請依照該品牌產品說明,如為 EDIMAX 無線分享器,請按約 2 秒後放開) 2. 請在 2 分鐘內,按下網路攝影機測邊下方的 WPS/Reset 按鍵(約 2~5 秒後放開),此時綠色 電源 LED 指示燈會呈現慢速閃爍,表示 WPS 功能已啟動 請注意: 因 WPS 及 Reset 為同一個按鍵,若 WPS 按鍵按太 久,恐怕不會啟動 WPS 反而會變成 Reset 重置,所以請勿久 按此鍵。 3.
使用本產品 如同使用 EdiLife App 一般,您可以使用網頁式管理介面觀看本產品所拍 攝的即時影像和進一步設定本產品功能,如移動及聲音偵測等。 請使用電腦開啟瀏覽器(確認該電腦與您的 IC-5150W 在同一個區域網 路),在網址列輸入前往本產品的 IP 位址: 您可以使用電腦透過 EdiView Finder 或也可使用手機 App — EdiLife (請至 Settings) 找到本產品的 IP 位址(請參閱使用手冊)。 10
壁架方式 本產品包裝內附壁裝支架,能讓您將本產品安裝在壁面,壁架的底座需 要使用工具簡單組裝。 1. 請使用包裝內附的螺絲和壁虎(如圖示),將壁架底座固定在牆面上: 2. 接著,請將本產品的背面壁架孔對準前述 1.
恢復出廠預設值 若您在使用本產品時,遭遇無法解決的問題,可以將本產品恢復成出廠 預設狀態(即所有設定將回到出廠預設值)。 1. 請按壓本產品本體側邊的 WPS/Reset 按鍵(至少 10 秒鐘),直到您看到 綠色的電源 LED 指示燈轉為快速閃爍的狀態,即可鬆開按鍵。 2.
Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
EU Declaration of Conformity English: This equipment is in compliance with the essential requirements and other relevant provisions of Directive 1995/95/EC, 2011/65/EC. Français: Cet équipement est conforme aux exigences essentielles et autres dispositions de la directive 1995/95/CE, 2011/65/CE. Čeština: Toto zařízení je v souladu se základními požadavky a ostatními příslušnými ustanoveními směrnic 1995/95/ES, 2011/65/ES.
Declaration of Conformity We, Edimax Technology Co., Ltd., declare under our sole responsibility, that the equipment described below complies with the requirements of the European R&TTE directive (1999/5/EC, 2006/95/EC) . Equipment: Model No.: 2MP Fisheye Wi-Fi Network Camera IC-5150W The following European standards for essential requirements have been followed: Spectrum: EMC: EMF: Safety (LVD): ETSI EN 300 328 V1.9.1 (2015-02) EN 301 489-1 V1.9.2 (2011-09); EN 301 489-17 V2.2.
Notice According to GNU General Public License Version 2 This product includes software that is subject to the GNU General Public License version 2. The program is free software and distributed without any warranty of the author. We offer, valid for at least three years, to give you, for a charge no more than the costs of physically performing source distribution, a complete machine-readable copy of the corresponding source code.
1. You may copy and distribute verbatim copies of the Program’s source code as you receive it, in any medium, provided that you conspicuously and appropriately publish on each copy an appropriate copyright notice and disclaimer of warranty; keep intact all the notices that refer to this License and to the absence of any warranty; and give any other recipients of the Program a copy of this License along with the Program.
Therefore, by modifying or distributing the Program (or any work based on the Program), you indicate your acceptance of this License to do so, and all its terms and conditions for copying, distributing or modifying the Program or works based on it. 6. Each time you redistribute the Program (or any work based on the Program), the recipient automatically receives a license from the original licensor to copy, distribute or modify the Program subject to these terms and conditions.