Instructions
V-5-2 Advanced
The “Advanced” page allows you to upgrade the network camera’s firmware,
backup or restore the network camera’s settings, and reset or restart the
network camera. Please check the Edimax website for the latest firmware for
your network camera.
Do not switch off or disconnect the device during a firmware
upgrade, as this could damage the device.
Firmware
Filename
Click “Browse” to locate the firmware file on your computer.
Upgrade
Firmware
Click to upgrade the firmware to your selected file.
Backup
Settings
Click “Apply” to save the current settings on your computer as
config.bin file.
Restore
Settings
Click “Browse” to find a previously saved config.bin file and
then click “Upload” to replace your current settings.
Restart
Click “Restart Network Camera” to restart the network camera.
Please wait a couple of minutes for network camera to boot up
after a restart. Restarting will not affect the camera’s current
configuration.
Reset to
Select “Keep Network Settings” or “Default Settings” and then